German CETA-CETatest 715 leakage tester
German CETA-CETatest 715 leakage tester
  • Product parameters
  • 适用范围
  • 产品描述
  • 参数配置

德国CETA-CETATEST 715 型泄漏测试仪

德国CETA-CETATEST 715 型泄漏测试仪

The working principle CETATEST 715 is a fully automatic leak detector designed to detect unsealed parts during the beat time of the production process. It contains a relative pressure sensor with a wide measurement range to measure pressure loss due to leakage within the test piece. Therefore, CETATEST715 is especially suitable for measuring parts with large leakage.
Way to workSingle channel operation
Signal processing

Fast 24 bit digital-to-analog converter

Real-time processing of measurement signal process

The valve typeDepending on application: slide or seat valve
Process controlReal-time microcontroller system, 16-bit μC / 40 MHz
The sensorRelative pressure transducer
Measuring rangeMax. 10,000 Pa, depending on test pressure (resolution: 1 Pa); Other ranges are subject to request
The unit displayPa, daPa, hPa, Pa/s, daPa/s, hPa/s, psi, psi/s, ml/min, ml/h, l/min, mbar l/s
Electronic adjustment test pressure range

-1 bar, 200 mbar, 1 bar, 10 bar

Negative and positive pressure gauges can be integrated (e.g. -1 bar/+1 bar), other ranges and mechanical pressure regulators as required

Test modePressure loss measurement, dynamic pressure test (option), Seal component test (option)
Test optionsPre-charging, programming, stable charging, parallel charging, charging and stability curve analysis, sequential zero measurement results, repeated measurement/automatic test time adjustment, each program can be controlled programmatically
System controlPressure supply monitoring
Programmable test phaseDelay, pre-inflation, inflation, stabilization, measurement, exhaust, container inflation, overflow, re-inflation
Test schema specific boundsPre-inflation pressure, inflation pressure, stable pressure (depending on firmware), test mode specific nonconformance and rework class
operationThe menu is intuitive and user rights are protected by password
Parameters of the stored64 separate programs sorted by first letter and number

Test program parameters can be imported and exported through test ports or USB storage devices

Additional featuresDetailed result statistics, cycle counter, maintenance interval indicator, reverse counter, parameter change record, measurement sequence and curve record, RS-232 programmable interface
interfaceSee table
Power supply and Consumption100 – 240 V AC, 47 – 63 Hz, 0.6 – 0.3 A Max60 W
Compressed air supply10 bar, above test pressure 0,5 bar, below emptying pressure 50 mbar(ISO 8573-1)
Pneumatic connection

Input: 6mm slide in connector

Test port: 3X 1.7mm connector, 3mm clasp (option)

Up to 3 pneumatic driven outputs (option)

sizeWidth: 345 mm, height: 145 mm (3U), Depth: 435 mm
weightabout 10 kg
The attachmentSpecial packaging, power cord, User manual, EC Compliance Declaration, including D-sub plug for input/output cable (PLC-communications)
The quality assurance period3 years, optionally extended to 5 years
Accessories (optional)Filter assembly, standard leak hole, three position two way valve, refer to CETA accessories catalog for more components


functionDigital INPUT/Output (standard)The RS - 232 (standard)Process Fieldbus DP (option)Ethernet (option)
Program selectionXXXX
Device status/system failureXXXX
Assessment (pass/fail)XXX X
A parameterized
The measured results
Fault Details

Relevant recommendations